Whips started as a dune flag with a light in it — something so the guy coming over the hill could see you before he landed on you. They still do that job. They also happen to look right on a lifted Squarebody, and this set does something most whips don't: it works as a turn signal and brake light too.

---

### What You Get

A pair of 3.8-foot RGB whips — 31mm x 1150mm each. Two lights, one for each corner or one on each side of the bed, however you want to run them.

### Turn Signal And Brake Light

This is the part that separates these from the average whip. They tie into your turn signals and brake lights, so when you're stopping or turning, the whips light up with them. On a tall truck at night, or on a trail with dust hanging in the air, that's real visibility — the guy behind you sees a four-foot column of light instead of a pair of taillights he's about to miss.

### Colors And Modes

Full RGB with 180 dynamic modes. Solid colors, chase patterns, or music mode that pulses with whatever's playing. Voice mode reacts to sound. Set them to match your rock lights and run the whole truck on one theme.

### The Spiral Design

Clear crystal tubing with a spiral LED layout, so you see the light from any angle instead of one bright side and one dead side. Bright, saturated color the whole way around the whip.

### Two Ways To Control Them

RF remote and the Cool Motor Bluetooth app. The app runs multiple sets together — so if you're already running Auxbeam RGB rock lights, these sync with them. Same colors, same patterns, one system across the whole truck.

### Pair Them With The KS-80 Switch Panel

If you're running the Auxbeam KS-80 knob switch panel, drop the whips on one of its eight circuits. You get hardware switching, master dimming, and factory triggers straight from the knob — the whips come on with the ignition, dim from the dash, or fire with everything else on the truck. The app sets your colors, the KS-80 runs them.

### Install

Mount to the bed rails, bumper, tire carrier, or roll bar — wherever you'd run a flag. Wire the RGB feed to your circuit, and tap the turn signal and brake leads into your existing rear harness. On a Squarebody that's a straightforward job with a test light and a wiring diagram.

### Fitment

Universal — they mount to any truck, UTV, ATV, or SUV. Not a Squarebody-specific part, and I won't pretend otherwise. What I can tell you is where they mount on these trucks and how to tap your signal and brake circuits clean without hacking up the factory harness.

### Why I Carry It

Most whips are just a light on a stick. These do the safety job *and* the show job, and they run on the same app as the rest of the Auxbeam RGB line, so your whole truck ends up on one system instead of three different remotes in the console.

---

### Straight Dealing

- **Auxbeam backs this with their own warranty.** If something fails, I'll point you straight to the right place instead of leaving you to dig for it.
- **If it shows up wrong or damaged, tell me first.** I'll make it right.
- **Questions before you buy or mid-install?** You reach a real person who actually knows these trucks — text me at 530-327-8811.

**Be seen. Then be seen.**